General Questions • [Software] wireguard not installing

Hello all

I'm Fairly inexperienced with all linux distros.

I am running debian 12 on a HP elite. I have been using this unit to run Home assistant supervisor within docker. Since January of this year I moved homer assistant to a proxmox vm on a dell server.

I would like to use this laptop to host wireguard server and i was following the instruction from the following website https://reintech.io/blog/configure-wire ... -debian-12

all was fine until i reached

systemctl enable wg-quick@wg0... this terminated correctly (i think because i got back to the prompt

systemctl start wg-quick@wg0 ... This command returned an exception
Job for wg-quick@wg0.service failed because the control process exited with error code

I tried again

I rebooted the laptop logged in as root with the same result
I ran sytemctl status wg-quick@wg0.service

loaded enabled preset enabled
active failed result exit-code

What did i do wrong?

Thank you for your reply

Statistics: Posted by wbravin — 2024-05-16 11:35 — Replies 3 — Views 46

---