Hardware • [Borked] Missing Nvidia graphics firmware

Hi,

I have installed Debian Bookworm on my Sony Viao laptop and it mostly runs just fine. However, "sudo dmesg" reports the following.

[ 68.448273] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084 (-2)
[ 68.448282] firmware_class: See https://wiki.debian.org/Firmware for information about missing firmware
[ 68.448295] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084 (-2)
[ 68.448298] nouveau 0000:01:00.0: Direct firmware load for nouveau/nvd9_fuc084 failed with error -2
[ 68.448312] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084d (-2)
[ 68.448326] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084d (-2)
[ 68.448329] nouveau 0000:01:00.0: Direct firmware load for nouveau/nvd9_fuc084d failed with error -2
[ 68.448331] nouveau 0000:01:00.0: msvld: unable to load firmware data
[ 68.448335] nouveau 0000:01:00.0: msvld: init failed, -19
[ 87.400257] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084 (-2)
[ 87.400303] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084 (-2)
[ 87.400313] nouveau 0000:01:00.0: Direct firmware load for nouveau/nvd9_fuc084 failed with error -2
[ 87.400347] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084d (-2)
[ 87.400372] nouveau 0000:01:00.0: firmware: failed to load nouveau/nvd9_fuc084d (-2)
[ 87.400378] nouveau 0000:01:00.0: Direct firmware load for nouveau/nvd9_fuc084d failed with error -2
[ 87.400384] nouveau 0000:01:00.0: msvld: unable to load firmware data
[ 87.400390] nouveau 0000:01:00.0: msvld: init failed, -19

A web search has revealed that this was was handled in "Debian Bug report logs - #990662". In particular, it would seem that I need to carry out the steps outlined in Message #22 therein. In my case I am not sure which NVIDIA ,run package to use. As the system reports the same error message as that given in Message #5 of that Debian Bug report, can I just use the same NVIDIA .run package as listed in Message #22 or do I need to use another NVIDIA .run package ?

"sudo lshw -C Display" reports the following.

*-display
description: VGA compatible controller
product: GF119M [GeForce 410M]
vendor: NVIDIA Corporation
physical id: 0
bus info: pci@0000:01:00.0
logical name: /dev/fb0
version: a1
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress vga_controller bus_master cap_list rom fb
configuration: depth=32 driver=nouveau latency=0 resolution=1600,900
resources: irq:28 memory:d2000000-d2ffffff memory:c0000000-cfffffff memory:d0000000-d1ffffff ioport:4000(size=128) memory:c0000-dffff

Stuart

Statistics: Posted by Stuarte — 2024-10-29 05:11 — Replies 2 — Views 100

---