Hi Everyone
I was wondering if someone could advise me on something
I was sent some drivers for a PS/2 touchscreen and I was told
If u are using PS2 interface, please make sure the following config is enabled.
(CONFIG_SERIO_RAW=y", ”CONFIG_SERIO_RAW=m")
eGTouchD require “/dev/serio_rawX” for access PS/2 port.
But I have No idea where I need to put them or what I need to do to get the screen to work so I can calibrate it (as I keep getting no touch screen found with I run the calibration tool)
This is the output from the Driver
I would appreciate ANY advise as this I think is beyond my understanding of Linux so I have reach out to the experts who know it better then me (after all I am only using it to power my EPoS Systems)
I was wondering if someone could advise me on something
I was sent some drivers for a PS/2 touchscreen and I was told
If u are using PS2 interface, please make sure the following config is enabled.
(CONFIG_SERIO_RAW=y", ”CONFIG_SERIO_RAW=m")
eGTouchD require “/dev/serio_rawX” for access PS/2 port.
But I have No idea where I need to put them or what I need to do to get the screen to work so I can calibrate it (as I keep getting no touch screen found with I run the calibration tool)
This is the output from the Driver
Code:
(I) Found uinput at path /dev/uinput(I) Place eGTouch driver archive to /usr/local/eGTouch64withX(I) Create eGTouch daemon shortcut in /usr/bin(I) Create eGTouchU tool shortcut in /usr/bin(I) Create eCalib tool shortcut in /usr/bin(I) Copy 99-egalax-udev.rules to /etc/udev/rules.d(I) Found PS2 mouse driver as serio1Statistics: Posted by gablea — 2024-02-28 21:30 — Replies 2 — Views 72